ND-70348 (E) CHAPTER 4
Page 500
Revision 3.0
ARTI
CDN
ROUTE NUMBER
TRUNK DATA
7 LLCRST Call Restriction by user rate in Low Layer Ca-
pability Information Element
0 = No restriction
1-31 = Call which includes this user rate value
is restricted. Note
Note: User rate value is based on
ITU-T Q-931.
8 VCM When assigning this data, zero (0) should al-
ways be entered.
0000
9 OVRT When assigning this data, zero (0) should al-
ways be entered.
0000
10 POOL When assigning this data, zero (0) should al-
ways be entered.
0000
11 DTRT Deletion of ALL 1 alarm signal (DTI Layer 1
alarm)
0 = Not used
1 = Deletion of ALL 1 alarm signal as a Layer
1 alarm
12 TMPRT Temporary Route Information over CCIS
0 = Not used
1 = In CCIS, the route information can be
transferred by the call control messages.
Moreover, the call restriction can be
checked referring to this route informa-
tion.
13 CODEC When assigning this data, zero (0) should al-
ways be entered.
0000
14 PASS When assigning this data, zero (0) should al-
ways be entered.
0000
15 IRL Clear call when DTI alarm is detected
0 = Not used
1 = Clear call when DTI alarm is detected
Note
Note: This data should be set
when there is no Dch in the
physical DTI.
16 MTC Assignment of Timer T309 Value.
Restoration timer (TC×MTC) sec.
0-15 = TC×MTC (Restart timer value)
17 TC Timer T309 Counter Value
0 = Not used 1 = 64 msec.
2 = Not used 3 = 2 sec.
4 = 30 sec. 5 = 5 min.
6 = 1 sec. 7 = Not used
To Next Page
Loading...
Need help?
General