ND-70348 (E) CHAPTER 4
Page 656
Revision 3.0
ASYDN
4. Data Sheet
Note: When setting outgoing restriction and toll restriction in the CCIS using the caller’s RSC transferred by a
call origination from the preceding office, data value “1” is assigned. Note, however, that destination re-
striction and number restriction cannot be made by use of RSC. This data is assigned “1” when the Autho-
rization Code, Call Waiting-Terminating, or EROW service is provided.
SYSTEM
DATA
TYPE
(SYS)
SYSTEM
DATA
INDEX
(INDEX)
0 -1535
DATA
(DATA)
00 – FF
(Hex)
BIT
CORRESPONDING
DATA
SYSTEM DATA CONTENTS (MDATA)
DATA
0/1
BIT
1
000 Not Used
300 Not Used
4
b
0
Control of ORT all Busy Status
0/1 = ROT/Wait for Off-hook Queue
0
b
1
Not Used
b
2
Releasing Method for Station to Station Calling Service
0 0=Calling Party release
0 1=Called Party release
1 0=First Party release
1 1=Both Party release
Normally assign “First Party release”
b
3
b
4
Temporary Class Conversion and OAI Free Location
Memory
0/1 = Not Required/Required Note
b
5
PAD Control of 16LC circuit card (for Station to Station
Calling only)
0/1: Required/Not Required
b
6
One Burst of Ringing On Call Forwarding (C.F.) phone
when C.F. – All Calls service has been assigned (analog
phones only).
0/1 = Not Required/Required
0
b
7
Not Used
~
~
~
To Next Page
Loading...
Need help?
General