Nokia 7330 - Page 595

FD 100/320Gbps NT and FX NT IHub Services Guide Virtual Private Routed Network Service
Issue: 13 3HH-11985-AAAA-TQZZA 595
Table 659 describes the detailed command output fields for a RIP group.
Table 659 Show RIP Detailed Command Output
Opr Down — The RIP neighbor interface is operationally down.
Up — The RIP neighbor interface is operationally up.
Primary IP The primary IP address of the RIP neighbor interface.
Send Mode Bcast — Specifies that RIPv2 formatted messages are sent to the broadcast
address.
Mcast — Specifies that RIPv2 formatted messages are sent to the multicast
address.
None — Specifies that no RIP messages are sent (i.e., silent listener).
RIPv1 — Specifies that RIPv1 formatted messages are sent to the broadcast
address.
Recv Mode Both — Specifies that RIP updates in either version 1 or version 2 format will be
accepted.
None — Specifies that RIP updates will not be accepted.
RIPv1 — Specifies that RIP updates in version 1 format only will be accepted.
RIPv2 — Specifies that RIP updates in version 2 format only will be accepted.
Metric In The metric added to routes received from a RIP neighbor.
Label Description
Neighbor The RIP neighbor name.
Description The RIP neighbor description. No Description Available indicates no description is
configured.
Primary IP The RIP neighbor interface primary IP address.
Group The RIP group name of the neighbor interface.
Admin State Down — The RIP neighbor interface is administratively down.
Up — The RIP neighbor interface is administratively up.
Oper State Down — The RIP neighbor interface is operationally down.
Up — The RIP neighbor interface is operationally up.
Send Mode Bcast — Specifies that RIPv2 formatted messages are sent to the broadcast
address.
Mcast — Specifies that RIPv2 formatted messages are sent to the multicast
address.
None — Specifies that no RIP messages are sent (i.e., silent listener).
RIPv1 — Specifies that RIPv1 formatted messages are sent to the broadcast
address.
Recv Mode Both — Specifies that RIP updates in either version 1 or version 2 format will be
accepted.
None — Specifies that RIP updates will not be accepted.
RIPv1 — Specifies that RIP updates in version 1 format only will be accepted.
RIPv2 — Specifies that RIP updates in version 2 format only will be accepted.
(1 of 2)
Label Description
(2 of 2)