Figure 76: Insert power supply
Legend
1 Power supply
2 Power supply compartment
3 Controller chassis
2 Listen for an audible click or feel the pow
er supply engage to conrm that
the power supply is properly seated.
Note: Repeat for each power supply. Also, replace the power supplies only
into the slots from which they had been removed.
Insert the Power Cord
Connect the power cord to the power supply.
Verify Controller Component Status
1 From Guided Maintenance, verify that the status is Normal.
You can also verify the status by navigating to System > Hardware and
then selecting a chassis. The Overview page for the selected chassis lists the
status of each component.
Note: The Controller status will be visible several minutes after being
powered on. The Oracle FS1 Flash Storage System must load the operating
system software on the Controller, then validate the status of the Controller
and the hardware before it will allow the Controller to rejoin the system
and return to Normal status.
2 Review the status of the LEDs to conrm a status of Normal.
Controller Replacement Procedures
108
To Next Page
Loading...
Need help?
General