Oracle FS1-2 - Remove a Fan Module

Figure 181: Pilot with fan door open
Legend
1 Fan door release tabs
2 Pilot fan door in open position
Caution: Close the Pilot fan door within 60 seconds to maintain adequate
airow to properly cool the serv
er.
Remove a Fan Module
1 Identify the faulted fan module and then, using your thumb and forenger
on both sides of the fan module tab, gently lift the fan module from the fan
compartment.
Each fan module has a status indicator (LED). If the LED is o, the fan is
operational. If the LED is lit amber, the fan has faulted. The LEDs are
located on the chassis mid-wall, adjacent to and aligned with the fan
modules.
Pilot Replacement Procedures
217