Oracle FS1-2

Table 3: Drive Enclosure component descriptions (continued)
Drive Enclosure component Component Type Hot serviceable
Two I/O modules (EBOD modules) CRU Yes
Two power cooling modules CRU Yes
Drive Enclosure drives are customer replaceable and hot serviceable. The
Oracle FS System release 6.1 supports the following driv
es:
Note: The list of supported drives can change. Refer to the release notes for your
release of the Oracle FS System for the corresponding list of supported drives.
Table 4: Release 6.1 supported drives
Drives and configurations Drive Enclosure type
•
2.5-inch (6.35-cm) SAS-2 small form
factor (SFF) HDDs, 300 GB
•
24 driv
es in a DE2-24P Drive
Enclosure
DE2-24P Drive Enclosure
•
2.5-inch (6.35-cm) SAS-2 SFF HDDs,
900 GB
•
24 drives in a DE2-24P Drive
Enclosure
DE2-24P Drive Enclosure
•
SSDs, 400 GB
•
Seven or 13 drives in a DE2-24P
Drive Enclosure
DE2-24P Drive Enclosure
•
SSDs, 1.6 TB
•
Seven, 13, or 19 drives in a DE2-24P
Drive Enclosure
DE2-24P Drive Enclosure
•
3.5-inch (8.89-cm) SAS-2 large form
factor (LFF) HDDs, 4 TB
•
24 drives in a DE2-24C Drive
Enclosure
DE2-24C Drive Enclosure
Pilot Components
When replacing a component, y
ou must know its part number and whether it is
hot serviceable. Having that information helps you to order the correct
replacement component and to determine whether you can replace the
component yourself. To locate a part number for the Pilot, open Oracle System
Handbook (hps://support.oracle.com/handbook_private/index.html) and go to
Introduction to Oracle FS1-2 System Service Procedures
27