Note: The fan module can be accessed only after removing the cov
er over the
Pilot chassis.
Note: To replace a fan module, you do not need to remove the Pilot from the rack
but extend it along the Pilot rails using the cable management arm (CMA).
Procedure Overview
1 Prepare a Pilot for Component Replacement
2 Slide Pilot to Service Position
3 Open Pilot Fan Door
4 Remove a Fan Module
5 Insert a Fan Module
6 Close Pilot Fan Door
7 Slide Pilot to Rack Position
8 Verify Component Replacement on the Standby Pilot
9 Verify Component Replacement on the Active Pilot
Related Links
Pilot Components
Prepare a Pilot for Component Replacement
1 Contact Oracle Customer Support prior to replacing a Pilot component.
Oracle Customer Support identies the failed component on the Pilot for
you.
2 From Oracle FS System Manager (GUI), navigate to System > Hardware >
Pilots and select the Pilot that contains the component that you want to
replace.
3 Select Actions > Repair Pilot.
Guided Maintenance displays the list of Pilot components.
4 Based on the information from your Oracle Customer Support
representative, select the correct component from the list.
5 Click Next.
Guided Maintenance sends a request to ash the white locate LED on the
Pilot to help you identify the Pilot in the data center.
6 Click Next.
Guided Maintenance displays a link that you use to access the instructions
for component replacement.
7 Click the link to open and print the procedure.
8 Click Next.
•
If you are replacing a component located on the active Pilot, Guided
Maintenance brings the active Pilot oine and fails over to the
Pilot Replacement Procedures
214
To Next Page
Loading...
Need help?
General