Prepare the Component for Replacement
1
From Oracle FS System Manager (GUI), navigate to System > Hardware >
Controllers and then select the Controller that contains the component that
is to be replaced.
2 Select Actions > View.
The View dialog displays the components in the Replaceable Unit list. The
Status column lists the status of each component. A status of Normal
requires no action.
Note: Field replaceable units (FRUs) can only be replaced by eld
technicians with support role privileges.
3 Select a component from the list and click Replace Component.
Guided Maintenance displays an image of the chassis.
4 Click Next.
Guided Maintenance displays the Identify Hardware dialog.
5 From the Identify Hardware dialog, specify how you want to identify the
chassis so that you can locate it in the data center.
You can select one of the following methods to identify the chassis:
Identify
Flashes the LEDs on the chassis that contains the failed component.
Reverse Identify
Flashes the LEDs on all of the chassis in the system except for the chassis that
contains the failed component.
6 Click Next.
Based on the method you selected to identify the chassis, the
corresponding LEDs ash to help you locate the chassis in the data center.
7 Click Next.
For components that are not hot-serviceable, Guided Maintenance sends a
request to bring the Controller oine and automatically initiate failover.
Guided Maintenance also displays an HTML link that you use to access the
instructions for component replacement.
For hot-serviceable components, Guided Maintenance completes the
process of preparing the system for component replacement and displays
the Replace Hardware dialog. The Replace Hardware dialog instructs you
to replace the component. You also receive a System Alert informing you
that the component is ready for removal. To review System Alerts,
navigate to System > Alerts and Events > System Alerts.
Slide Controller to Service Position
Controller Replacement Procedures
123
To Next Page
Loading...
Need help?
General