Note: The risers can be accessed only after removing the top cov
er over the
Controller chassis.
Note: To replace a riser, you do not need to remove the Controller from the rack
but extend it along the Controller rails using the cable management arm (CMA).
Note: Ensure that all power is removed from the Controller before replacing the
riser. Disconnect the power cords before performing the riser replacement
procedure.
Procedure Overview
1 Prepare the Component for Replacement
2 Slide Controller to Service Position
3 Remove the Controller Power Supply Cords
4 Disconnect Controller Cabling
5 Open the Controller Top Cover
6 Remove a Riser
7 Insert a Riser
8 Close the Controller Top Cover
9 Reconnect Controller Cabling
10 Complete the Component Replacement
11 Verify Controller Component Status
Related Links
Controller Components
Prepare the Component for Replacement
1 From Oracle FS System Manager (GUI), navigate to Support > System
Trouble.
2 Select the Controller that contains the component that is to be replaced.
3 Select Actions > Replace Component.
Guided Maintenance displays the list of replaceable components for the
Controller.
Note: Field replaceable units (FRUs) can only be replaced by eld
technicians with support role privileges.
4 Select a component from the list.
5 Click Next.
Guided Maintenance displays the Identify Hardware dialog.
6 From the Identify Hardware dialog, specify how you want to identify the
chassis so that you can locate it in the data center.
Controller Replacement Procedures
110
To Next Page
Loading...
Need help?
General