Oracle FS1-2 - Warnings and Cautions; Electrostatic Discharge Precautions; Required Tools

Related Links
Replace a Pilot Baery
Replace a Pilot SAS HDD
Replace a Pilot SAS HBA
Replace a Pilot Riser
Replace a Pilot Power Supply
Replace a Pilot Fan Module
Replace a Pilot DIMM
Replace a Pilot Chassis
Warnings and Cautions
Hazard signal w
ords conform to the American National Standards Institute
(ANSI) Z535.4-2002 meanings.
Caution: Indicates a potentially hazardous situation that, if not avoided, may
result in minor or moderate injury.
Danger: Indicates an imminently hazardous situation that, if not avoided, will
result in death or serious injury.
Tip: To indicate best practices for a process.
Important: To emphasize a point, to remind you of something, or to indicate
potential problems in the outcome of the in-process task.
Electrostatic Discharge Precautions
Caution: Before you handle a component, make sure that you have taken
electrostatic discharge (ESD) precautions:
•
The minimum requirement is an anti-static wrist strap connected to a hard
ground. Remove components from their packaging and place them on an
ESD-qualied table that is equipped with ground points for wrist straps.
•
Static charges can build up rapidly on rolling carts. If you transport a
hardware component by cart, ground the cart with a drag chain on an ESD
oor. If there is no ESD cart available or ESD oor, ground yourself before
you touch a component that has been transported on a cart.
Required Tools
Before starting the installation of a Oracle Flash Storage System, be sure you have
the needed equipment and tools available.
Introduction to Oracle FS1-2 System Service Procedures
31