Oracle FS1-2

6 At the back of the rack, adjust the length of the left rail as needed to t the
rack, and position the rail ange ov
er the face of the rack rail.
Figure 14: Left rail adjusted at the back of the rack
Legend
1 Back of the rack
2 Left rail
7 Align the rail ange so that the mounting holes correspond to those at the
front of the rack.
8
Use a Phillips screwdriver to insert and tighten four metric M6 screws (two
on each side) at the back of the rail.
9 Repeat the above three steps for the right rail.
10 Using a Phillips Number 2 screwdriver, tighten the eight 10-32 panhead
adjustment screws (four on each side) toward the back of each rail.
Install the Slide Rails for the Controller
1 Extend the mounting brackets completely out of their respective slide rails.
Tip: To extend the mounting brackets out of the slide rails, simultaneously
press and hold the upper and lower lock buons of the slide rail lock.
Then, pull the mounting bracket out until it locks in the extended position.
Oracle FS1–2 Global Procedures
48