Table 28: High voltage three-phase PDU for Oracle Flash Storage Systems
(continued)
High Voltage 3Ph (5W + ground)
Outlet groups for each PDU 6
PDU power cord length 2 meters (6.6 feet)
PDU pow
er cords are 4 meters (13 feet)
long, but sections are connected for internal
routing in the rack.
System Power Requirements
The total pow
er consumed by the Oracle FS1 Flash Storage System is dependent
on the conguration of the system. To determine the system electrical input
ratings for Oracle Flash Storage Systems that use the Oracle supported PDUs,
refer to the PDU information provided for Oracle Flash Storage Systems.
Oracle Flash Storage Systems require redundant input power feeds for proper
fault tolerant operation.
Note: Ensure that you have the exact power load and current requirements for
your specic Oracle FS System at hand.
If non-Oracle PDUs are used, you must determine the electrical input ratings of
the Oracle FS System conguration.
System Packaging and Transportation
All packaging and transportation are tested in accordance with Oracle Shipping
Package Test, Doc. No. 950-1291-01.
System Environmentals
Table 29: System altitude specifications
Mode Elevation
Operational –196 to 10498.7 feet (–60 to 3,200 meters)
Non-operational –196 to 40026.2 feet (–60 to 12,200 meters)
Oracle FS System Hardware Specifications
239
To Next Page
Loading...
Need help?
General