You can select one of the following methods to identify the chassis:
Identify
Flashes the LEDs on the chassis that contains the failed component.
Reverse Identify
Flashes the LEDs on all of the chassis in the system except for the chassis that
contains the failed component.
7 Click Next.
Based on the method y
ou selected to identify the chassis, the
corresponding LEDs ash to help you locate the chassis in the data center.
8 Click Next.
Guided Maintenance sends a request to shut down the software running
on the Controller and automatically initiates failover. Guided Maintenance
also displays an HTML link that you use to access the instructions for
component replacement.
Slide Controller to Service Position
Squeeze the release buons on either side of the Controller front panel at
the same time and slide the Controller chassis forward until the slide rails
lock into position. You might have to remove screws locking the front
panel to the rack before the Controller slides forward.
Caution: Deploy any rack anti-tilt mechanism before releasing the release
buons and extending the Controller chassis.
Controller Replacement Procedures
111
To Next Page
Loading...
Need help?
General