Caution: W
ork with a partner or use a mechanical lift for assistance. The Pilot
weighs approximately 18.1 kilograms (39.9 pounds). Two people are required to
carry the chassis.
1 Slowly pull the Pilot out of the rack until the slide rails reach their stops.
2 Verify that the CMA extends fully from the slide rails.
3 Push the Pilot back into the rack.
When the Pilot is fully extended, you must release two sets of slide rail
stops to return the Pilot to the rack:
•
The rst set of stops are levers, located on the inside of each slide
rail, just behind the back panel of the Pilot. These levers are labeled
“PUSH.” Push in both levers simultaneously, and slide the Pilot
toward the rack. The chassis slides in approximately 46 cm (18
inches) and stops. Verify that the cables and the CMA retract without
binding before you continue.
•
The second set of stops are the slide rail release buons, located near
the front of each mounting bracket. Simultaneously push both of the
green slide-rail release buons, and push the Pilot completely into
the rack until both slide-rail locks engage.
4 Adjust the cable straps and CMA, as required.
Oracle FS1–2 Global Procedures
89
To Next Page
Loading...
Need help?
General