Rohde & Schwarz R&S SMW200A - Page 1081

Remote Control Commands
R&S
®
SMW200A
1081User Manual 1175.6632.02 ─ 30
Parameters:
<Start> float
Range: -80 to 0
Increment: 0.01
*RST: 0
Example: see "Programming Examples" on page 1071
Manual operation: See "Power Start" on page 404
[:SOURce<hw>]:BB:MCCW:EDIT:CARRier:PHASe:STEP <Step>
For disabled optimization of the crest factor, sets the step width by which the start
phase of the carriers in the defined carrier range is incremented.
Parameters:
<Step> float
Range: -359.99 to 359.99
Increment: 0.01
*RST: 0
Example: See "Programming Examples" on page 1071
Manual operation: See "Phase Step" on page 404
[:SOURce<hw>]:BB:MCCW:EDIT:CARRier:POWer:STEP <Step>
Sets the step width by which the starting power of the carriers in the defined carrier
range is incremented.
Parameters:
<Step> float
Range: -80 to 80
Increment: 0.01
*RST: 0
Example: See "Programming Examples" on page 1071
Manual operation: See "Power Step" on page 404
[:SOURce<hw>]:BB:MCCW:EDIT:CARRier:STARt <Start>
[:SOURce<hw>]:BB:MCCW:EDIT:CARRier:STOP <Stop>
Defines the first/last carrier in the carrier range to which joint configuration applies.
Parameters:
<Stop> integer
Range: 0 to 8191
*RST: 0
Example: See "Programming Examples" on page 1071
Manual operation: See "Carrier Start/Stop" on page 403
SOURce Subsystem