Rohde & Schwarz R&S SMW200A - Page 1102

Remote Control Commands
R&S
®
SMW200A
1102User Manual 1175.6632.02 ─ 30
Parameters:
<Skew> float
Range: -500E-9 to 500E-9
Increment: 1E-12
*RST: 0
Manual operation: See "Skew" on page 445
[:SOURce<hw>]:IQ:IMPairment[:STATe] <State>
[:SOURce]:BB:IMPairment:BBMM<ch>:STATe <State>
[:SOURce]:BB:IMPairment:FADer<ch>:STATe <State>
[:SOURce]:BB:IMPairment:IQOutput<ch>:STATe <State>
[:SOURce]:BB:IMPairment:RF<ch>:STATe <State>
Activates the impairment or correction values LEAKage, QUADrature and IQRatio
for the corresponding stream.
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 0
Example:
SOURce1:BB:IMPairment:RF1:STATe ON
Activates digital impairment.
Manual operation: See "State" on page 444
[:SOURce]:BB:IMPairment:BBMM<ch>:POFFset <PhaseOffset>
[:SOURce]:BB:IMPairment:FADer<ch>:POFFset <PhaseOffset>
[:SOURce]:BB:IMPairment:IQOutput<ch>:POFFset <PhaseOffset>
[:SOURce]:BB:IMPairment:RF<ch>:POFFset <PhaseOffset>
Adds an additional phase offset after the stream mapper.
You can shift the phase at the different stages in the signal generation flow, see:
●
[:SOURce<hw>]:BB:POFFset on page 986
●
:SCONfiguration:OUTPut:MAPPing:STReam<st>:POFFset on page 921
Parameters:
<PhaseOffset> float
Range: -999.99 to 999.99
Increment: 0.01
*RST: 0
Example:
SOURce:BB:IMPairment:RF1:POFFset 0
Manual operation: See "Phase Offset" on page 446
SOURce Subsystem