Rohde & Schwarz R&S SMW200A - Page 1103

Remote Control Commands
R&S
®
SMW200A
1103User Manual 1175.6632.02 ─ 30
[:SOURce<hw>]:BB:IMPairment:OPTimization:MODE <Mode>
Sets the optimization mode.
Parameters:
<Mode> FAST | | QHIGh | QHTable
FAST
Optimization by compensation for I/Q skew.
QHTable
Improved optimization by maintained speed.
QHIGh
Optimization by compensation for I/Q skew and frequency
response correction.
This mode interrupts the RF signal. Do not use it in combination
with the uninterrupted level settings and strictly monotone
modes RF level modes.
(See [:SOURce<hw>]:POWer:LBEHaviour on page 1192.)
*RST:
FAST
*RST: FAST (R&S SMW-B10) / QHIGh (R&S SMW-B9) /
QHTable (if R&S SZU connected to R&S SMW and the connec-
tion is active)
Example:
:SOURce1:IQ:SOURce BASeband
:SOURce1:BB:IMPairment:OPTimization:MODE FAST
Manual operation: See "Optimization Mode" on page 453
14.19.4.7 SOURce:BB:GRAPhics Subsystem
This subsystem contains the commands used to setup the graphical display.
Required options
See Chapter 9.1.1, "Required Options", on page 597.
[:SOURce<hw>]:BB:GRAPhics:MODE........................................................................... 1103
[:SOURce<hw>]:BB:GRAPhics:SRATe:MODE.................................................................1104
[:SOURce<hw>]:BB:GRAPhics:SRATe:USER................................................................. 1104
[:SOURce]:BB:GRAPhics:CLOSe.................................................................................. 1104
[:SOURce]:BB:GRAPhics:ADD...................................................................................... 1105
[:SOURce]:BB:GRAPhics:SOURce................................................................................ 1105
[:SOURce]:BB:GRAPhics:SOURce:MUX........................................................................ 1105
[:SOURce]:BB:GRAPhics:FFTLen..................................................................................1106
[:SOURce]:BB:GRAPhics:FFTFscale..............................................................................1106
[:SOURce<hw>]:BB:GRAPhics:TRIGger:SOURce........................................................... 1106
[:SOURce<hw>]:BB:GRAPhics:MODE <Mode>
Selects the graphics mode of the graphical signal display.
SOURce Subsystem