Rohde & Schwarz R&S SMW200A - Page 1113

Remote Control Commands
R&S
®
SMW200A
1113User Manual 1175.6632.02 ─ 30
Example: Querying the status of the Create Waveform file process
The following is an example on how to use these commands to retrieve information
about how many percent of the initiated process are completed.
:SCONfiguration:MODE ADVanced
:SCONfiguration:FADing MIMO4x4
:SCONfiguration:BASeband:SOURce COUPled
:SCONfiguration:APPLy
:SOURce1:BB:EUTRa:SETTing:TMOD:DL "E-TM1_1__15MHz"
:SOURce1:BB:EUTRa:SLENgth 100
:SOURce1:BB:PROGress:MCODer?
// 100 (task compleated)
:SOURce1:BB:EUTRa:STATe ON
:BB:PROGress:MCODer?
// 67 (task in progress)
:SOURce1:BB:EUTRa:WAVeform:CREate
:SOURce1:BB:PROGress:MCODer?
// 25 (task in progress)
// :SOURce1:BB:PROGress:MCODer:DM:FILTer?
// 100
[:SOURce<hw>]:BB:PROGress:MCODer?...................................................................... 1113
[:SOURce<hw>]:BB:PROGress:MCODer:ARBitrary:MCARrier?........................................ 1113
[:SOURce<hw>]:BB:PROGress:MCODer:ARBitrary:WSEGment?..................................... 1113
[:SOURce<hw>]:BB:PROGress:MCODer:DM:FILTer?...................................................... 1113
[:SOURce<hw>]:BB:PROGress:MCODer?
[:SOURce<hw>]:BB:PROGress:MCODer:ARBitrary:MCARrier?
[:SOURce<hw>]:BB:PROGress:MCODer:ARBitrary:WSEGment?
Queries the status of an initiated process, like for example the calculation of a signal in
accordance to a digital standard, or the calculation of a multi-carrier or multi-segment
waveform file.
Return values:
<WSegment> integer
Indicates the task progress in percent
Range: 0 to 100
*RST: 100
Example: See Example "Querying the status of the Create Waveform file
process" on page 1113
Usage: Query only
[:SOURce<hw>]:BB:PROGress:MCODer:DM:FILTer?
Queries the status of an applied offline filtering, like for example during the calculation
of a waveform and a multi carrier waveform file.
SOURce Subsystem