Rohde & Schwarz R&S SMW200A - Page 391

Configuring the Internal Baseband Source
R&S
®
SMW200A
391User Manual 1175.6632.02 ─ 30
This multi-carrier waveform is saved with filename specified in "Output File". Depend-
ing on the configuration of the multi-carrier waveform, calculation can take some time.
To stop the calculation, use the "Abort" function.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:MCARrier:CREate on page 1052
[:SOURce<hw>]:BB:ARBitrary:MCARrier:CLOad on page 1051
5.11.3.2 Carrier Table Settings
Access:
1. Select "Baseband > ARB > General > Multi Carrier".
2. Select "ARB: Multi Carrier > Carrier Table"
This tab comprises the settings of the individual carriers. A selectable carrier range
can be set with the aid of the optional "Carrier Table Assistant".
The settings of all available carriers are displayed in table form. Previously applied
assistant settings can be further refined. The number of lines corresponds to the
number of carriers.
The "Phase / deg" settings are only valid if optimization of the crest factor is disabled
("Crest Factor Mode" = "Off").
Use the "Carrier Graph" tab to visualize the selected multi-carrier configuration.
Settings:
Number of Carriers......................................................................................................392
No................................................................................................................................392
State............................................................................................................................392
Carrier Freq [MHz]...................................................................................................... 392
Gain.............................................................................................................................392
Phase..........................................................................................................................392
Generating Multi-Carrier Signals