Rohde & Schwarz R&S SMW200A - Page 392

Configuring the Internal Baseband Source
R&S
®
SMW200A
392User Manual 1175.6632.02 ─ 30
Delay...........................................................................................................................392
File.............................................................................................................................. 392
Info.............................................................................................................................. 393
!!!................................................................................................................................. 393
Number of Carriers
Defines the number of carriers of the multi-carrier waveform.
This parameter is identical to the one in the "General Setting" section.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:MCARrier:CARRier:COUNt on page 1048
No
Indicates the carrier index ranging from 0 to (number of carriers -1).
Remote command:
Individual carriers are set by the index at the keyword CARR
State
Switches On/Off a carrier.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:MCARrier:CARRier<ch>:STATe on page 1052
Carrier Freq [MHz]
Sets the carrier frequency.
Note: The carrier frequency can only be set in "Arbitrary Carrier frequency" mode. For
"Equidistant Carrier Spacing", the carrier spacing is determined automatically.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:MCARrier:CARRier<ch>:FREQuency
on page 1053
Gain
Sets the gain of a carrier.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:MCARrier:CARRier<ch>:POWer on page 1053
Phase
Sets the starting phase of a carrier.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:MCARrier:CARRier<ch>:PHASe on page 1053
Delay
Sets the starting delay of a carrier.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:MCARrier:CARRier<ch>:DELay on page 1054
File
Accesses the standard "File Select" function for selecting the input file. The input file
contains the I/Q signal that is modulated onto the carrier.
Generating Multi-Carrier Signals