Rohde & Schwarz R&S SMW200A - Page 394

Configuring the Internal Baseband Source
R&S
®
SMW200A
394User Manual 1175.6632.02 ─ 30
Settings:
Carrier State................................................................................................................394
Carrier Start/Start........................................................................................................394
Gain Start....................................................................................................................394
Gain Step.................................................................................................................... 394
Phase Start................................................................................................................. 394
Phase Step..................................................................................................................395
Delay Start.................................................................................................................. 395
Delay Step...................................................................................................................395
Input Waveform File.................................................................................................... 395
Apply Assistant Settings..............................................................................................395
Carrier State
Switches the carriers in the range "Carrier Start" to "Carrier Stop" on/off.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:MCARrier:EDIT:CARRier:STATe on page 1054
Carrier Start/Start
Defines the start/stop index of the carrier range to which the assistant settings are
intended to apply.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:MCARrier:EDIT:CARRier:STARt on page 1055
[:SOURce<hw>]:BB:ARBitrary:MCARrier:EDIT:CARRier:STOP on page 1055
Gain Start
Sets the gain of the carrier marked by "Carrier Start".
Remote command:
[:SOURce<hw>]:BB:ARBitrary:MCARrier:EDIT:CARRier:POWer[:STARt]
on page 1055
Gain Step
Sets the step width that is used to increment the gain.
The resulting carrier gain in the carrier table equals:
Gain = "Gain Start" + n*"Gain Step".
n is a value between 0 and the difference of "Carrier Stop" and "Carrier Start".
Remote command:
[:SOURce<hw>]:BB:ARBitrary:MCARrier:EDIT:CARRier:POWer:STEP
on page 1055
Phase Start
Sets the phase of the carrier marked by "Carrier Start".
Remote command:
[:SOURce<hw>]:BB:ARBitrary:MCARrier:EDIT:CARRier:PHASe[:STARt]
on page 1056
Generating Multi-Carrier Signals