Rohde & Schwarz R&S SMW200A - Page 395

Configuring the Internal Baseband Source
R&S
®
SMW200A
395User Manual 1175.6632.02 ─ 30
Phase Step
Sets the step width that is used to increment the phase.
The resulting phase in the carrier table equals:
Phase =
"Phase Start" + n*"Phase Step"
n is a value between 0 and the difference of "Carrier Stop" and "Carrier Start".
Remote command:
[:SOURce<hw>]:BB:ARBitrary:MCARrier:EDIT:CARRier:POWer:STEP
on page 1055
Delay Start
Sets the delay of the carrier marked by "Carrier Start".
Remote command:
[:SOURce<hw>]:BB:ARBitrary:MCARrier:EDIT:CARRier:DELay[:STARt]
on page 1057
Delay Step
Sets the step width that is used to increment the delay.
The resulting delay in the carrier table equals:
Delay = "Delay Start" + n*"Delay Step",
n is a value between 0 and the difference of "Carrier Stop" and "Carrier Start".
Remote command:
[:SOURce<hw>]:BB:ARBitrary:MCARrier:EDIT:CARRier:DELay:STEP
on page 1056
Input Waveform File
Accesses the standard "File Select" function for selecting the input file. The input file
contains the I/Q signal to be modulated onto all carriers of the selected carrier range.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:MCARrier:EDIT:CARRier:FILE on page 1057
Apply Assistant Settings
Transfers the assistant settings to the carrier table.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:MCARrier:EDIT:CARRier:EXECute
on page 1057
5.11.3.4 Carrier Graph
Access:
1. Select "Baseband > ARB > General > Multi Carrier".
Generating Multi-Carrier Signals