Rohde & Schwarz R&S SMW200A - Page 400

Configuring the Internal Baseband Source
R&S
®
SMW200A
400User Manual 1175.6632.02 ─ 30
The remote commands required to define these settings are described in Chap-
ter 14.19.4.4, "SOURce:BB:MCCW Subsystem", on page 1070.
Settings:
5.12.3.1 General Carrier Settings
Access:
► Select "Baseband > Multi-Carrier CW".
Settings:
State............................................................................................................................400
Set to Default.............................................................................................................. 401
Number of Carriers......................................................................................................401
Carrier Spacing........................................................................................................... 401
Bandwidth................................................................................................................... 401
Clock Frequency......................................................................................................... 401
Optimize Crest Factor Mode....................................................................................... 402
Desired Crest Factor...................................................................................................402
State
Enables/disables the Multi-Carrier CW.
Switching on this option, turns off all the other digital standards and digital modulation
modes in the corresponding signal path.
Generating Multi-Carrier Continuous Wave Signal