Rohde & Schwarz R&S SMW200A - Page 575

Configuring the RF Signal
R&S
®
SMW200A
575User Manual 1175.6632.02 ─ 30
Access to "Edit List Mode Data":
► "RF" > "Sweep/List" > "List Mode" > "List Mode Data" > "Edit List Mode Data"
The editor for list mode provides a table with RF frequency and power values, an
extra column for defining variable dwell times, and standard navigation functions.
The remote commands required to define the list mode data are described in
Chapter 14.19.12, "SOURce:LIST Subsystem", on page 1164.
Access to "Edit User Correction Data":
► "RF" > "RF Level" > "User Correction" > "Edit User Cor. Data"
The editor for user correction data provides a table with RF frequency and power
values and standard navigation functions.
The remote commands required to define the user correction data are described in
Chapter 14.19.5, "SOURce:CORRection Subsystem", on page 1114.
Improving Level Performance