Rohde & Schwarz R&S SMW200A - Page 576

Configuring the RF Signal
R&S
®
SMW200A
576User Manual 1175.6632.02 ─ 30
All columns in a row must contain values. Cells with missing values are therefore filled
automatically, using the value of the previous row.
If you use global dwell time in list mode, consider also that the instrument uses the
value set with Global Dwell Time for all list steps and not the values from the list.
Since the table and navigation functions can be assumed to be known, the following
description contains a brief overview, shown by the example of the "Edit List Mdoe
Data" dialog. If a function relates to a particular dialog, it is explicitly stated.
Settings
Edit List Mode Data.....................................................................................................576
Data handling keys......................................................................................................576
└ Go To............................................................................................................ 577
└ Edit................................................................................................................577
└ Fill with Sensor..............................................................................................577
└ Save As/Save............................................................................................... 577
Fill................................................................................................................................577
Edit List Mode Data
Table with values for list or user correction processing.
Note: Once you enter a value, the editor automatically adds preset values in the other
columns. This functionality protects against data loss, otherwise incomplete rows are
lost when saving. You can simply override these values.
"Frequency /Hz"
Sets the frequency values.
Remote command:
[:SOURce<hw>]:LIST:FREQuency on page 1170
[:SOURce<hw>]:CORRection:CSET:DATA:FREQuency on page 1116
"Power /dBm" (list mode data table)
Sets the level values.
Remote command:
[:SOURce<hw>]:LIST:POWer on page 1173
"Correction Value /dBm" (user correction data table)
Sets the level values.
Remote command:
[:SOURce<hw>]:CORRection:CSET:DATA:POWer on page 1117
"Dwell /s"
In list mode, sets the dwell time values.
Remote command:
[:SOURce<hw>]:LIST:DWELl:LIST on page 1169
Data handling keys
Standard functions for file and data handling.
Improving Level Performance