Rohde & Schwarz R&S SMW200A - Page 578

Configuring the RF Signal
R&S
®
SMW200A
578User Manual 1175.6632.02 ─ 30
"Increment Value"
Determines the step size.
"Fill"
Fills the column specified in "Column To fill".
8.9.3.3 Fill with Sensor
Access:
1. Select "RF" > "RF Level" > "User Correction".
2. Select "User Cor. Data > navigate to the file *.ucor > Select"
3. Select "Edit User Cor. Data > Fill With Sensor..."
This dialog contains parameters for filling a table automatically with sensor read-
ings.
To fill the table, select "Execute".
For information on power sensors an how to use them, see Chapter 8.9.5, "How to Cal-
ibrate the Power Level with an R&S NRP Power Sensor", on page 593.
Settings
Fill User Correction Data with Sensor......................................................................... 578
Used SMW Settings For Measurement.......................................................................579
Fill User Correction Data with Sensor
●
"Sensor"
Displays connected sensors for selection.
●
"List To Fill"
Improving Level Performance