Configuring the RF Signal
R&S
®
SMW200A
579User Manual 1175.6632.02 ─ 30
Indicates the used list.
●
"Use SParameter"
Indicates whether SParameter correction in the R&S NRP power sensor is used.
●
"Include Zeroing"
Performs a zeroing procedure before acquiring the user correction data to improve
precision.
No signal is applied to the sensor during zeroing. RF output is temporarily switched
off during that time.
When unchecked, the zeroing procedure is skipped. However, the RF signal level
might be blanked shortly. This setting is useful if blanking of RF is undesirable or
the absence of power at the sensor cannot be guaranteed.
●
"Execute"
The "Execute" button is only enabled if a sensor is detected and the user correction list
contains at least one frequency value.
Remote command:
[:SOURce<hw>]:CORRection:ZERoing:STATe on page 1118
[:SOURce<hw>]:CORRection:CSET:DATA[:SENSor<ch>][:POWer]:SONCe
on page 1117
Used SMW Settings For Measurement
Displays the settings relevant for the measurement.
"RF Source"
Shows the path for which the correction menu settings are made.
"Modulation"
Indicates the modulation state
"Amplitude"
Shows the currently set level.
Remote command:
n.a.
8.9.3.4 Import/Export List Files
Access:
1. Select one of the following:
● "RF" > "Sweep/List" > "List mode".
● "RF" > "RF Level" > "User Correction".
Improving Level Performance
To Next Page
Loading...