Rohde & Schwarz R&S SMW200A - Page 606

Monitoring Signal Characteristics
R&S
®
SMW200A
606User Manual 1175.6632.02 ─ 30
Figure 9-9: Graphics configuration dialog with active graphical signal displays
5. To enlarge the thumbnail, select it.
Settings:
Graphical Diagrams Table...........................................................................................606
Mode........................................................................................................................... 606
Source.........................................................................................................................606
Mux Stream.................................................................................................................607
FFT Length..................................................................................................................607
Full Scale (dBFS)........................................................................................................607
Trigger Source.............................................................................................................607
Sample Rate Mode..................................................................................................... 608
Sample Rate............................................................................................................... 608
Add..............................................................................................................................608
Apply Changes............................................................................................................608
Remove.......................................................................................................................608
Graphical Diagrams Table
The active graphical signal displays are listed in the table at the top of the dialog.
Mode
Determines the graphics mode, see Chapter 9.1, "Displaying Baseband Signal Charac-
teristics in Real-Time", on page 597.
Remote command:
[:SOURce<hw>]:BB:GRAPhics:MODE on page 1103
Source
Defines the signal acquisition point, see Chapter 9.1.2.2, "Signal Acquisition Points",
on page 602.
External digital baseband signals fed via the [FADER] connectors cannot be monitored.
Displaying Baseband Signal Characteristics in Real-Time