Getting Started
R&S
®
SMW200A
74User Manual 1175.6632.02 ─ 30
EUTRA/LTE to introduce the way you can access and interact with the instrument and
experience the advantages provided by the additional options.
The minimum requirement for R&S SMW in this example is a base unit equipped with
the additional option R&S SMW-K55 EUTRA/LTE.
To generate a downlink test signal
The main focus of the following example is not on the R&S SMW capabilities and the
features provided by the firmware option. The example aims rather to help you get
familiar with the settings and configuration principle common for the digital standards.
We use one of the provided EUTRA test models (E-TM) to show how to generate a
test signal upon a quick selection.
1. On the R&S SMW front panel, press the [PRESET] key to start out in a defined
instrument configuration.
2. In the block diagram, select "Baseband > Beyond 3G Standards > EUTRA/LTE".
The EUTRA/LTE dialog appears and displays the general settings provided for the
digital standard.
As in the user interfaces of all digital standards, the "EUTRA/LTE" dialog is divided
into several tabs. The "General" tab comprises the primary settings of the standard,
the functions for storing and recalling settings and provides access to further func-
tions and dialogs, like the "Filter" settings. The "Trigger In", "Marker" and "Clock"
tabs comprise the settings related to the corresponding function.
The more complex the digital standard itself is, the more comprehensive the further
dialog and tab structure. The start dialog of each digital standard, however, follows
a repeating dialog structure that comprises the tabs "General", "Trigger In",
"Marker" and "Clock". (See also Chapter 3.5.3.4, "Additional Display Characteris-
tics", on page 95).
Tip: To display the dialog in its maximal height, press the [RESIZE WINDOW] key
on the front panel.
3. In the "EUTRA/LTE General" tab, select "Test Models".
Trying Out the Instrument
To Next Page
Loading...