Rohde & Schwarz R&S SMW200A - Page 758

General Instrument Functions
R&S
®
SMW200A
758User Manual 1175.6632.02 ─ 30
The "SW Update" tab enables you to lock front panel operation and/or reading the
display.
The remote commands available to control security settings are described in:
●
Chapter 14.12, "DISPlay Subsystem", on page 874
●
Chapter 14.20, "SYSTem Subsystem", on page 1217.
Annotation Frequency
Enables the display of the currently used frequency in the status bar.
How to: see "Disabling the frequency and level indication in the status bar"
on page 766.
Remote command:
:DISPlay:ANNotation:FREQuency on page 876
Annotation Amplitude
Enables the display of the currently selected level in the status bar.
How to: see "Disabling the frequency and level indication in the status bar"
on page 766.
Remote command:
:DISPlay:ANNotation:AMPLitude on page 875
User Interface
Allows you to lock the controls for manual operation and the display individually.
How to: see "Deactivating the user interface" on page 766.
See also Chapter 12.6, "Using the Security Settings", on page 752.
"Enabled"
Enables the display and all controls for the manual operation of the
instrument.
Using the Security Settings