Network Operation and Remote Control
R&S
®
SMW200A
791User Manual 1175.6632.02 ─ 30
The "Instrument Emulations" dialog enables you to emulate a remote control com-
mand set of another signal generator.
The remote commands required to configure the emulation settings remotely are
described in Chapter 14.20, "SYSTem Subsystem", on page 1217.
Language
Selects the instrument whose remote command set is emulated by the R&S SMW.
Remote command:
:SYSTem:LANGuage on page 1234
Mode
Selects the way the instrument identification is performed.
"Automatic"
Sets the "IDN String" and the "OPT String" automatically for the
instrument selected with the parameter Language.
"User Defined"
Enables you to define the "IDN String" and the "OPT String".
Remote command:
:SYSTem:IDENtification on page 1233
Set to Default
In "Mode > User Defined", resets the *IDN and *OPT strings.
Remote command:
:SYSTem:IDENtification:PRESet on page 1233
IDN String
Indicates the identification string of the instrument when queried with the common
command *IDN?.
In addition to the preset values, you can define your own identification string so that
each generator uses an individual identification, like My_SigGen for instance, see
Mode .
Remote command:
*IDN? on page 845
:SYSTem:IRESponse on page 1233
Remote Access Settings
To Next Page
Loading...