Rohde & Schwarz RTM3K-COM2

Remote control commands
R&S
®
RTM3000
534User Manual 1335.9090.02 ─ 09
Suffix:
<m>
.
1, the suffix is irrelevant.
Parameters:
<State> ON | OFF
ON
Cursor lines keep their relative position to the waveform.
OFF
Cursor lines remain on their position on the display if the scaling
is changed.
*RST: OFF
CURSor<m>:SPPeak<n>
CURSor<m>:SNPeak<n>
Set the cursor line to the previous / next peak, respectively. The command is only
available for FFT waveforms.
Suffix:
<m>
.
1, the suffix is irrelevant.
<n> 1..2
Selects the cursor line.
Usage: Event
17.7.3.2 Cursor measurement results
To get the measurement values of vertical cursor lines (time, frequency for FFT), use:
●
CURSor<m>:X1Position on page 532
●
CURSor<m>:X2Position on page 532
To get the measurement values of horizontal cursor lines (voltage, current, level for
FFT), use:
●
CURSor<m>:Y1Position on page 533
●
CURSor<m>:Y2Position on page 533
CURSor<m>:XDELta[:VALue]?........................................................................................534
CURSor<m>:XDELta:INVerse?....................................................................................... 535
CURSor<m>:YDELta[:VALue]?........................................................................................535
CURSor<m>:YDELta:SLOPe?.........................................................................................535
CURSor<m>:XDELta[:VALue]?
Returns the time difference between two vertical cursor lines (Δt).
Suffix:
<m>
.
1, the suffix is irrelevant.
Measurements