Remote control commands
R&S
®
RTM3000
541User Manual 1335.9090.02 ─ 09
MASK:TEST <Test>
Starts, finishes or interrupts a mask test.
Parameters:
<Test> RUN | STOP | PAUSe
*RST: STOP
MASK:RESet:COUNter
Sets the counters of passed and failed acquisitions to zero.
Usage:
Event
MASK:COUNt?
Returns the number of tested acquisitions.
Return values:
<TotalCount> Total number of tested acquisitions
Usage: Query only
MASK:VCOunt?
Returns the number of acquisitions that hit the mask.
Return values:
<ViolationCount> Total number of violations
Usage: Query only
MASK:CAPTure[:MODE] <CaptureMode>
Only available with history. The command selects whether all acquisitions are stored in
segments, or only failed acquisition. You can use the history to analyze the segments.
Parameters:
<CaptureMode> ALL | FAILED
*RST: ALL
17.8.2.4 Mask data
Use the following commands that are described in Chapter 17.9.1.5, "Masks",
on page 577:
●
MASK:DATA? on page 577
●
MASK:DATA:HEADer? on page 577
●
MASK:DATA:XINCrement? on page 579
●
MASK:DATA:XORigin? on page 579
Applications
To Next Page
Loading...
