Rohde & Schwarz RTM3K-COM2

Remote control commands
R&S
®
RTM3000
556User Manual 1335.9090.02 ─ 09
Return values:
<ResultLevel>
Usage: Query only
SPECtrum:MARKer:RESult<n>:LEVel:DELTa?
Returns the delta level, the difference between the level of the specified marker and
the level of the reference marker.
Suffix:
<n>
.
*
Return values:
<ResultLevelDifference>
Usage: Query only
17.8.4.5
Display settings for spectrum and spectrogram
SPECtrum:FREQuency:BANDwidth[:RESolution]:AUTO.................................................... 556
SPECtrum:DIAGram:COLor:MAGNitude:MODE................................................................556
SPECtrum:DIAGram:COLor:MAXimum[:LEVel]................................................................. 556
SPECtrum:DIAGram:COLor:MINimum[:LEVel].................................................................. 557
SPECtrum:DIAGram:COLor:SCHeme:FDOMain............................................................... 557
SPECtrum:DIAGram:COLor:SCHeme:SPECtrogram......................................................... 557
SPECtrum:DIAGram:SPECtrogram[:ENABle]....................................................................557
SPECtrum:FREQuency:BANDwidth[:RESolution]:AUTO <AutoSpanRBWratio>
Enables the auto resolution bandwidth mode. In the auto mode "Span": "RBW" ratio of
~1:100 is set.
Parameters:
<AutoSpanRBWratio>ON | OFF
*RST: ON
SPECtrum:DIAGram:COLor:MAGNitude:MODE <MagnitudeMode>
Enables the magnitude coloring of the waveform.
Parameters:
<MagnitudeMode> ON | OFF
SPECtrum:DIAGram:COLor:MAXimum[:LEVel] <MaximumLevel>
Sets the level used as a maximum of the color scale selected with SPECtrum:
DIAGram:COLor:SCHeme:SPECtrogram/SPECtrum:DIAGram:COLor:SCHeme:
FDOMain.
All level values lower than the minimum are displayed with the minimum color.
Applications