Rohde & Schwarz RTM3K-COM2

Remote control commands
R&S
®
RTM3000
724User Manual 1335.9090.02 ─ 09
Usage: Query only
POWer:HARMonics:DOFRequency <DoFrequency>
Selects the frequency of the input signal if POWer:HARMonics:STANdard is set to
RTC.
Parameters:
<DoFrequency> F400 | NVF | WVF
POWer:HARMonics:ENFRequency
<ENFrequency>
Selects the frequency of the input signal if POWer:HARMonics:STANdard is set to
ENA/ENB/ENC/END.
Parameters:
<ENFrequency> AUTO | F50 | F60
POWer:HARMonics:EXECute
Starts the current harmonics measurement.
Usage:
Event
POWer:HARMonics:MEASurement:DURation?
Returns the time duration of the measurement.
Return values:
<MeasurementDuration>
Usage: Query only
POWer:HARMonics:MEASurement:FREQuency:AVG?
Returns the average frequency of the measured signal.
Return values:
<AverageValue>
Usage: Query only
POWer:HARMonics:MEASurement:FREQuency:NPEak?
Returns the minimum frequency of the measured signal.
Return values:
<MinimumValue>
Usage: Query only
Power analysis (option R&S RTM-K31)