Rohde & Schwarz RTP044 - Jitter Measurements; Jitter Measurements (Option R&S RTP-K12)

Jitter analysis and clock data recovery
R&S
®
RTP
1013User Manual 1337.9952.02 ─ 12
See: Chapter 18.2, "Advanced jitter and noise (option R&S RTP- K133/K134)",
on page 1022.
● Jitter measurements (Option R&S RTP-K12)..................................................... 1013
● Advanced jitter and noise (option R&S RTP- K133/K134)..................................1022
● Clock data recovery............................................................................................ 1056
18.1 Jitter measurements (Option R&S RTP-K12)
This chapter describes the measurement setup in the "Jitter" category.
● Jitter measurements............................................................................................1013
● Jitter measurement settings................................................................................1015
● Jitter statistics and histogram..............................................................................1021
● Track of jitter measurement results.....................................................................1021
● Jitter spectrum.....................................................................................................1022
18.1.1 Jitter measurements
The measurement category "Jitter" gathers all measurements which are useful for jitter
analysis. The category contains jitter-specific measurements. In addition, the following
amplitude/time measurements are added to the jitter category, because they are useful
for jitter analysis:
●
Period
●
Frequency
●
Setup time
●
Hold time
●
Setup/Hold ratio
The amplitude/time measurements are described in "Time measurements"
on page 354.
The specific jitter measurements are described in Table 18-1.
Jitter measurements (Option R&S RTP-K12)