Rohde & Schwarz RTP044 - Aux out

Remote control commands
R&S
®
RTP
1249User Manual 1337.9952.02 ─ 12
Suffix:
<m>
.
1..4
The suffix is irrelevant. The setting affects all active channels.
Parameters:
<ExtendSkew> ON | OFF
*RST: OFF
Usage: Asynchronous command
22.8.12 AUX OUT
CALibration:SOURce:FREQuency................................................................................. 1249
CALibration:SOURce:STATe..........................................................................................1249
CALibration:SOURce:FREQuency <Frequency>
Frequency value and waveform type of the internal calibration source, which is output
at the [Aux Out] connector.
Parameters:
<Frequency> KHZ7900 | MHZ10 | KHZ15800 | MHZ31_25 | KHZ31600 |
KHZ63200 | GHZ1 | MHZ250MB | MHZ250mb | GHZ1_20DB |
MHZ62 | MHZ125 | MHZ250 | MHZ500 | KHZ505500 | MHZ1R |
MHZ31R | MHZ31_25R | MHZ498S | MHZ1257_2S |
MHZ2491S | MHZ4060S | MHZ4350S | MHZ4810S |
MHZ4991S | MHZ5940S | MHZ1R | MHZ31R | MHZ31_25R |
MHZ498S | MHZ1257_2S | MHZ2491S | MHZ4350S |
MHZ4810S | MHZ4991S | MHZ4060S | MHZ5940S
MHZ1R | MHZ31R | MHZ31_25R | MHZ498S | MHZ1257_2S |
MHZ2491S | MHZ4350S | MHZ4810S | MHZ4991S | MHZ4060S
| MHZ5940S
Square wave 1MHz, 31 MHz, 31.25 MHz
Sine wave 498 MHz, 1257.2 MHz, 2491 MHz, 4350 MHz, 4810
MHz, 4991 MHz, 4060 MHz, 5940 MHz
*RST:
MHZ1R
Example:
CAL:SOUR:FREQ GHZ1
CAL:SOUR:STAT ON
The commands activate the 1 GHz reference frequency.
Usage: Asynchronous command
CALibration:SOURce:STATe <State>
Defines the state of the internal calibration source.
Parameters:
<State> ON | OFF
*RST: OFF
Acquisition and setup