Rohde & Schwarz RTP044 - Trigger Sequence

Remote control commands
R&S
®
RTP
1309User Manual 1337.9952.02 ─ 12
TRIGger<m>:LEVel<n>:NOISe:PERDivision <HystInDivs>
Defines a range in divisions around the trigger level. If the signal oscillates inside this
range and crosses the trigger level thereby, no trigger event occurs.
Suffix:
<m>
.
1..3
Irrelevant, omit the suffix.
<n> 1..31
Indicates the trigger source: see TRIGger<m>:LEVel<n>:
NOISe[:STATe] on page 1307.
Parameters:
<HystInDivs> Hysteresis size in divisions
Range: 0 to 5
Increment: 0.01
*RST: 0
Default unit: div
Usage: Asynchronous command
TRIGger<m>:LEVel<n>:NOISe:RELative <HystRel>
Defines a range in percent around the trigger level. If the signal oscillates inside this
range and crosses the trigger level thereby, no trigger event occurs.
Suffix:
<m>
.
1..3
Irrelevant, omit the suffix.
<n> 1..31
Indicates the trigger source: see TRIGger<m>:LEVel<n>:
NOISe[:STATe] on page 1307.
Parameters:
<HystRel> Hysteresis in %. 10% = 1 div
Range: 0 to 50
Increment: 1
*RST: 0
Default unit: %
Usage: Asynchronous command
22.9.19 Trigger sequence
TRIGger<m>:EVENt.....................................................................................................1310
TRIGger<m>:SEQuence:TYPE..................................................................................... 1310
TRIGger<m>:ECOupling...............................................................................................1311
TRIGger<m>:SEQuence:DELay.................................................................................... 1311
TRIGger<m>:SEQuence:COUNt....................................................................................1311
Trigger