Waveform generator (Option R&S RTP-B6)
R&S
®
RTP
980User Manual 1337.9952.02 ─ 12
Amplitude parameters
Couples all amplitude parameters of "Gen1" to "Gen2" or "Gen2" to "Gen1" including
the load. The values are taken from the currently selected generator.
●
For all "Operation Mode": the output settings except of "Load" and "Inversion",
"Amplitude", "High", "Offset" and "Low".
●
For "Operation Mode" > "Function Gen.": "DC Level"
●
For "Operation Mode" > "Modulation": "Modulation depth"
Remote command:
WGENerator<m>:COUPling[:FREQuency] on page 2240
Frequency parameters
Couples all frequency parameters of "Gen1" to "Gen2" or "Gen2" to "Gen1". The val-
ues are taken from the currently selected generator.
●
For "Operation Mode" > "Function Gen.": "Frequency" and "Period"
●
For "Operation Mode" > "Modulation": "Carrier frequency", "Carrier period", "Modu-
lation freq", "Freq deviation", "Frequency 1", "Frequency 2" and "Hop rate"
●
For "Operation Mode" > "Sweep": "Start frequency", "Stop frequency" and "Sweep
time".
●
For "Operation Mode" > "Arbitrary": "Arb wfm source" and "Signal source".
You can still change the other settings of the generators independently.
Remote command:
WGENerator<m>:COUPling:AMPLitude on page 2239
Phase shift
Sets the phase shift between the waveform of "Gen1" and "Gen2" when the frequency
parameters of the two waveforms are coupled.
Remote command:
WGENerator<m>:COUPling:PHASeshift on page 2239
Noise parameters
Couples all noise parameters of "Gen1" to "Gen2" or "Gen2" to "Gen1". The values are
taken from the currently selected generator.
Remote command:
WGENerator<m>:COUPling:NOISe on page 2240
Arbitrary waveform
Available for General settings = "Arbitrary".
Couples the arbitrary waveform "Gen1" to "Gen2" or "Gen2" to "Gen1". The values are
taken from the currently selected generator.
Remote command:
WGENerator<m>:COUPling:NOISe on page 2240
15.5 Sync settings
Access: [Gen] > "Sync"
Sync settings
To Next Page
Loading...
