Rohde & Schwarz RTP044 - Configuring the Search Results Presentation

Search functions
R&S
®
RTP
470User Manual 1337.9952.02 ─ 12
11.4.3 Configuring the search results presentation
Initially, the "Search Results" box is displayed in front of the other diagrams or as result
icon on the signal bar. This depends on the default setting in the "Diagram Layout" tab.
Alternatively, you can display it in its own area on the screen, like any other diagram.
For details, see Chapter 3.3.7, "Displaying results", on page 80.
To configure the result tables
1. Open the search dialog: "Menu" > "Apps" > "Analysis" tab > "Search".
2. Select the tab for the search you want to configure.
3. Select the "Display" tab.
4. Select "Show result table" to display the "Search Results" box.
5. Select the sort mode of the result table.
6. By default, the results are listed in descending order, i.e. the largest value at the
top. To change the sorting direction, enable "Sort ascending".
7. Define a maximum number of results to be displayed in the result table in the "Max.
result count" field.
To display search zoom windows
1. In the "Search > Display" tab, enable "Show result zoom".
This stops a running search and a running acquisition.
The zoom area is indicated in the diagram that displays the source waveform of the
search. The zoom window is displayed for the first result that was found.
2. If you need to adjust the search zoom area, you can drag the area or their edges
on the screen. You can also enter the limits of the search zoom window in the
"Search > Display > Define result zoom".
Be aware, that the zoom window size is valid for all results of a search definition. If
you change the settings drastically for one result, they may not be correct for the
next search result you switch to.
See also:
● Chapter 7.1.3, "Zooming for details", on page 278
Search display presentation