Rohde & Schwarz RTP044 - Digital Channels

Remote control commands
R&S
®
RTP
2197User Manual 1337.9952.02 ─ 12
To prevent an overlapping execution of commands, one of the commands *OPC,
*OPC? or *WAI can be used after the command or a command set.
For more information, see:
●
www.rohde-schwarz.com/rc-via-scpi, chapter "Command Sequence and Synchro-
nization"
●
Chapter 22.3, "Programming examples", on page 1126
● Digital channels...................................................................................................2197
● Parallel bus configuration....................................................................................2200
● Digital resolution..................................................................................................2207
● Trigger settings for digital signals and parallel buses......................................... 2208
● MSO data............................................................................................................2217
22.18.1 Digital channels
All DIGital: commands affect only the settings of the first MSO bus (Bus1). The set-
tings of all other parallel buses (Bus 2, 3,4) remain unchanged.
DIGital<m>:DISPlay..................................................................................................... 2197
DIGital<m>:TECHnology...............................................................................................2197
DIGital<m>:THReshold.................................................................................................2198
DIGital<m>:THCoupling................................................................................................2198
DIGital<m>:HYSTeresis................................................................................................ 2198
DIGital<m>:LABel........................................................................................................ 2199
DIGital<m>:DESKew....................................................................................................2199
DIGital<m>:DISPlay <Display>
Enables or disables the indicated digital channel, displays it, and enables the parallel
Bus1 if the bus was disabled. That is, BUS<m>:PARallel:DISPlay:SHDI and
BUS<m>:PARallel:STATe are set to ON automatically.
If another active bus already uses the selected digital channel, the instrument disables
the other bus to avoid conflicts.
For Bus1, the DIG:DISP command has the same effect as BUS<m>:PARallel:
BIT<n>[:STATe]. To enable digital channels for buses 2, 3 and 4, use the
BUS:PAR:BIT[:STAT] command.
Suffix:
<m>
.
0..15
Number of the digital channel
Parameters:
<Display> ON | OFF
DIGital<m>:TECHnology <Technology>
Selects the threshold voltage for various types of integrated circuits and applies it to all
digital channels.
Mixed signal option (MSO, R&S
RTP-B1)