Rohde & Schwarz RTP044 - High-Speed Serial Pattern Settings

Triggers
R&S
®
RTP
256User Manual 1337.9952.02 ─ 12
Pattern settings
The pattern settings depend on the selected "Pattern type", see Chapter 6.10.2, "High-
speed serial pattern settings", on page 256.
6.10.2 High-speed serial pattern settings
Access: "Menu" > "Trigger" > "Setup" tab > "Type = Serial Pattern"
The available settings depend on the selected "Pattern type".
6.10.2.1 Basic settings for serial pattern trigger
In the basic serial pattern settings, you can define the clock signal in relation to which
you want to trigger. You can use the recovered clock signal for the serial pattern trigger
("CDR " > ON) instead of a real clock signal.
You can set the same settings in two dialogs:
●
Access: "Menu" > "Trigger" > "Setup" tab > "Type = Serial Pattern"
●
Access: [App Cockpit] > "Analysis " > "CDR" >"Hardware" tab.
See also Chapter 18.3, "Clock data recovery", on page 1056.
High-speed serial pattern trigger (Option R&S
RTP-K140/K141)