Rohde & Schwarz RTP044 - Measurement Appearance Settings

Instrument setup
R&S
®
RTP
107User Manual 1337.9952.02 ─ 12
Cursor style
Defines how the cursor is displayed in the diagram.
"Lines"
The cursors are displayed as lines.
"Line & Rhom-
bus"
The cursors are displayed as lines. The intersections of the cursors
with the waveforms are displayed by rhombus-shaped points.
"Vertical line
and rhombus"
The cursors are displayed as vertical lines. The intersections of the
cursors with the waveforms are displayed by rhombus-shaped points.
"Rhombus"
The intersections of the cursors with the waveforms are displayed by
rhombus-shaped points.
Remote command:
CURSor<m>:STYLe on page 1174
Result position
Defines the position of the cursor measurement results.
"Floating"
Floating result box in front of the diagrams.
"Preview"
Result icon on the signal bar.
"Docked"
Fixed tab below the diagrams.
Remote command:
DISPlay:RESultboxes:CUPosition on page 1175
4.3.8 Measurement appearance settings
Access: "Settings" > "Appearance" > "Measurement" tab
Appearance settings