Instrument setup
R&S
®
RTP
118User Manual 1337.9952.02 ─ 12
4.5.2 Knobs
Access: "Settings" > "Frontpanel" > "Knobs"
Vertical.........................................................................................................................118
Horizontal.................................................................................................................... 118
Acceleration method....................................................................................................118
Acceleration interval.................................................................................................... 118
Vertical
The vertical Position knob can change the waveform position or the offset of the
selected waveform. Select the action that you want to perform.
See also: "[Position] (upper knob)" on page 56
Horizontal
The horizontalPosition knob can change the horizontal position or the reference point.
Select the action that you want to perform.
See also:"[Position]" on page 54
Acceleration method
Selects a method to accelerate the movement of the element on the screen compared
to the actual movement of the [Navigation] knob.
Acceleration is useful if you need to move from one end of the screen to the other, for
example. Without acceleration, you have to turn the knob quite a while to reach the
other end. On the other hand, acceleration can make precise selection difficult, since a
small movement of the knob causes a relatively large movement on the screen.
"None"
No acceleration method used.
"Squared"
Moderate acceleration method used.
"Exponential"
Strong acceleration method used.
Acceleration interval
Defines the delay time during which the movement of the [Navigation] knob is analyzed
before acceleration is applied. For short intervals, acceleration sets in quickly, but is
not as effective. For long intervals, acceleration is more effective. However, it takes lon-
ger until the instrument reacts on the knob's input.
Frontpanel settings
To Next Page
Loading...
