Rohde & Schwarz RTP044 - LIN (Option R&S RTP-K3)

Remote control commands
R&S
®
RTP
1657User Manual 1337.9952.02 ─ 12
22.17.7 LIN (option R&S RTP-K3)
● Configuration.......................................................................................................1657
● Trigger.................................................................................................................1659
● Decode results.................................................................................................... 1665
● LIN search settings............................................................................................. 1672
● LIN search results............................................................................................... 1679
22.17.7.1 Configuration
BUS<m>:LIN:DATA:SOURce........................................................................................ 1657
BUS<m>:LIN:DATA:THReshold..................................................................................... 1657
BUS<m>:LIN:TECHnology............................................................................................1658
BUS<m>:LIN:BITRate.................................................................................................. 1658
BUS<m>:LIN:POLarity..................................................................................................1658
BUS<m>:LIN:STANdard............................................................................................... 1659
BUS<m>:LIN:DATA:SOURce <DataSource>
Sets the waveform of the data line.
Suffix:
<m>
.
1..4
Selects the serial bus.
Parameters:
<DataSource> C1W1 | C2W1 | C3W1 | C4W1 | M1 | M2 | M3 | M4 | M5 | M6 |
M7 | M8 | R1 | R2 | R3 | R4 | D0 | D1 | D2 | D3 | D4 | D5 | D6 |
D7 | D8 | D9 | D10 | D11 | D12 | D13 | D14 | D15
See Chapter 22.4.2, "Waveform parameter", on page 1145
*RST: C1W1
Usage: Asynchronous command
BUS<m>:LIN:DATA:THReshold <Threshold>
Sets a user-defined threshold value.
Alternatively, you can set the threshold according to the signal technology with
BUS<m>:LIN:TECHnology.
Suffix:
<m>
.
1..4
Selects the serial bus.
Parameters:
<Threshold> Range: -12 to 12
Increment: 0.1
*RST: 0
Default unit: V
Protocols