Getting started
R&S
®
RTP
73User Manual 1337.9952.02 ─ 12
3. To change the size of a diagram, tap the handle between two diagram frames and
drag it to the required position.
Remote commands: see Chapter 22.7.2.4, "Smartgrid", on page 1163.
3.3.6 Toolbar
The toolbar provides direct access to important control and measurement functions.
By default, the toolbar shows the most frequently used functions. You can configure the
content of the toolbar, see Chapter 3.3.6.2, "Configuring the toolbar", on page 74.
3.3.6.1 Using the toolbar
Using the toolbar is easy and straightforward.
Some of the toolbar functions are one-click actions. These actions are performed
immediately when you tap the icon.
Other toolbar functions are analyzing functions. These actions are interactive actions.
To use analyzing functions (interactive actions)
1. If several waveforms are shown in the diagram, select the waveform that you want
to analyze.
See: "To select a waveform" on page 71
Operating the instrument
To Next Page
Loading...
