Rohde & Schwarz RTP044 - Basic Trigger Settings

Triggers
R&S
®
RTP
215User Manual 1337.9952.02 ─ 12
The settings in the tab are:
● Basic trigger settings.............................................................................................215
● Edge......................................................................................................................217
● Glitch.....................................................................................................................218
● Width.....................................................................................................................219
● Runt.......................................................................................................................220
● Window................................................................................................................. 222
● Timeout................................................................................................................. 223
● Interval.................................................................................................................. 224
● Slew rate............................................................................................................... 226
● Setup & Hold trigger..............................................................................................227
● State......................................................................................................................229
● Pattern...................................................................................................................230
● Serial pattern.........................................................................................................232
● TV/Video trigger.................................................................................................... 232
● Line trigger............................................................................................................ 237
● Triggering on serial buses.....................................................................................237
● Triggering on parallel buses and digital channels................................................. 237
6.3.1 Basic trigger settings
"Setup"Access: "Menu" > "Trigger" > "Setup" tab
The basic trigger settings are the trigger source and the trigger type, including the trig-
ger level. These settings are specific for each condition in a trigger sequence. To set
the trigger level automatically, use "Find level".
Depending on the trigger type, additional settings are available. They are explained in
the trigger-type specific sections.
Trigger on
Selects, if you want to trigger on a single event, or on a series of events.
Remote command:
TRIGger<m>:EVENt on page 1254
Trigger types