Remote control commands
R&S
®
RTP
2303User Manual 1337.9952.02 ─ 12
Return values:
<MaxFilterAtt> Range: -1E+9 to 1E+9
Increment: 0.01
*RST: 0
Default unit: dB
Usage: Query only
DEEMbedding<m>:MGAin?
Maximum gain of the measurement setup before deembedding, with reference to a fre-
quency response normalized at DC to 0 dB. The deembedding filter must attenuate the
amplitude response by this value. The value helps also to avoid an overload of the
ADC.
Suffix:
<m>
.
1..4
Selects the channel that is configured for deembedding.
Return values:
<MaxFilterGn> Range: -1E+9 to 1E+9
Increment: 0.01
*RST: 0
Default unit: dB
Usage: Query only
22.24 Maintenance
Some of the commands in the following chapter are asynchronous. An overlapping or
asynchronous command does not automatically finish executing before the next com-
mand starts executing. If overlapping commands must be executed in a defined order,
e.g. to avoid wrong measurement results, they must be serviced sequentially.
To prevent an overlapping execution of commands, one of the commands *OPC,
*OPC? or *WAI can be used after the command or a command set.
For more information, see:
●
www.rohde-schwarz.com/rc-via-scpi, chapter "Command Sequence and Synchro-
nization"
●
Chapter 22.3, "Programming examples", on page 1126
DIAGnostic:SERVice:WFAModel?..................................................................................2304
DIAGnostic:SERVice:WFASeries?................................................................................. 2304
DIAGnostic:SERVice:WFAType?....................................................................................2304
CALibration:DATE?...................................................................................................... 2304
CALibration:TIME?.......................................................................................................2304
CALibration:RESult?.....................................................................................................2305
Maintenance
To Next Page
Loading...
