Rohde & Schwarz RTP044 - Screenshots

Remote control commands
R&S
®
RTP
1539User Manual 1337.9952.02 ─ 12
To set the export data format, use FORMat[:DATA].
Return values:
<Data> List of values according to the format settings
Long term data:
If statistics are disabled, the current value of each long term
point is returned.
If statistics are enabled (MEASurement<m>:STATistics[:
ENABle]), seven values for each long term point are returned:
upper peak, lower peak, RMS, standard deviation, average,
number of measured results per long term point, number of
waveforms per long term point.
For measurement histograms, absolute values are returned.
See also: Chapter 12.2.5, "Result plots analysis", on page 497.
Example:
See "Transferring long-term measurement data" on page 1131
Usage: Query only
22.16.9 Screenshots
The HCOPy subsystem and some other commands control the output of display infor-
mation for documentation purposes. The instrument allows two independent output
configurations which can be set separately with the suffix.
Note that the remote mode is intended for maximum performance. Therefore, the dis-
play does not follow the remote commmands consistantly. To get a correct screenshot,
turn the display on using SYST:DISP:UPD ON.
HCOPy:DESTination<1..2>........................................................................................... 1539
MMEMory:NAME......................................................................................................... 1540
HCOPy:DEVice<m>:LANGuage.................................................................................... 1540
HCOPy:DEVice<m>:INVerse.........................................................................................1540
HCOPy:WBKG............................................................................................................ 1541
HCOPy:CMAP<m>:DEFault..........................................................................................1541
HCOPy:SSD................................................................................................................1541
HCOPy:ISBA...............................................................................................................1542
HCOPy:IMMediate<m>[:DUM].......................................................................................1542
HCOPy:IMMediate<m>:NEXT....................................................................................... 1542
HCOPy:DESTination<1..2> <Medium>
Selects the output medium: file, printer or clipboard.
Suffix:
<1..2>
.
Selects the output configuration.
Parameters:
<Medium> MMEM | SYST:COMM:CLIP
String parameter
Data management