Rohde & Schwarz RTP044 - Calibration Results; Probe Adapter R&S RT-Z1 M; Probe Adapter R&SRT-Z1 M

Acquisition and waveform setup
R&S
®
RTP
189User Manual 1337.9952.02 ─ 12
Remote commands:
●
PROBe<m>:ID:SWVersion? on page 1227
●
PROBe<m>:ID:PRDate? on page 1227
●
PROBe<m>:ID:PARTnumber? on page 1227
●
PROBe<m>:ID:SRNumber? on page 1228
●
PROBe<m>:SETup:CAPacitance? on page 1228
●
PROBe<m>:SETup:IMPedance? on page 1228
5.6.10 Calibration results
To check the attributes of the connected probes, select "Info" > "Cal Results" in the
"Probes" tab.
5.6.11 Probe adapter R&S RT‑Z1M
Using the R&S RT‑Z1M probe adapter, you can connect probes requiring 1 MΩ load
impedance to the R&S RTP, which has inputs with 50 Ω impedance. The
Rohde & Schwarz probe interface at the adapter input allows you to connect various
probes, e.g. passive probes, current probes, and active probes with Rohde & Schwarz
probe interface.
1. Connect the R&S RT‑Z1M adapter to the channel input.
The instrument identifies the adapter.
Probes